About Alarm sounds Milestone 312 provides a selection of alarm sounds since firmware 4.47. Four alarm sounds have been added. In addition, the default two-tone sound is available in two volumes, high and medium. In total, the standard package provides the following 6 sounds: 1. Default two-tone, high. 2. Cuckoo, high. 3. Two-tone remix, high. 4. Melody 1, high. 5. Rooster, high. 6. Default two-tone, mid. The above listed standard package of Alarm sounds you can adjust in the support area of Milestone 312 on www.bones.ch. You have the possibility to add 3 new Alarm sounds on your Milestone 312. Additionally, you can download two further volume levels of each Alarm sound. The standard package is equipped with the highest volume level. If that is too loud you can replace it by downloading any Alarm sound in the volume level „Mid“ or „Low“. Installation: - Recommended: Install the newest Firmware on your Milestone 312. - Choose an Alarm sound and download it. - Unzip the download and copy the file with ending .pak to the root directory of an SD memory card. - Insert the CD card into the active Milestone 312. Milestone immediately installs the new Alarm sound. Hint: A new Alarm sound will be added to the standard package. But if you download a new volume level of an existing Alarm sound it will overwrite the old Alarm sound. Hint: You have the possibility to erase Alarm sounds you do not like. Therefore go to the setting „Alarm sound“ and select the one you do not like. Press the ordinary delete combination with „Mode“ and „Play“ to ged rid of the sound. Please be aware that when you delete all Alarm sounds Milestone will fall back to the default two-tone sound.